Using concrete website banner

Water In The Basement - Part 4

Water leaks or seepage in your basement will damage stored items, destroy finished walls and flooring, but more importantly it becomes the perfect breeding area for mold. Where there is mold, there is the possibility of respiratory problems, allergies and odors. These contaminants will eventually permeate throughout your home.

Common Areas of Water Seepage:

Mortar Joints

Window Wells

Over The Top Of Foundation Wall

Cracks In Foundation Wall

Tie Rod

Pipe Penetration

Porous Concrete

Cove Joint

Floor Drain

Crack In Concrete Floor

Water Seepage Due To Porous Concrete - Figures 13 & 14

Water seepage due to porous concrete
Figure 13 - Water seepage due to porous concrete
spalled concrete
Figure 14 - Spalled concrete

Porous concrete, or as it is known in the trade as honeycomb concrete usually occurs when the concrete has not been thoroughly mixed and the Portland cement has not covered all of the gravel within the concrete mixture. Spalled concrete occurs over time as the concrete naturally deteriorates the surface layer begins to wear down.

Spalled or honeycombed concrete may also accompany vertical cracking as shown in Figure 14.

The best remedy for honeycomb or spalled concrete is to apply a membrane over the area on the outside of the wall where the damage has occurred. If the areas that are damaged are relatively small, they can be repaired on the interior side of the wall by using specially formulated concrete resurfacing compounds.

Do-it-yourself concrete wall crack repair information.

Water Seepage At The Cove Joint - Figures 15, 16 & 16b

Water seepage from cove joint
Figure 15 - Water seepage from cove joint
Drain under basement concrete floor
Figure 16 - Drain pipe installed under basement concrete floor

The area where either a poured concrete wall or a block wall meets the floor is called the cove joint. This joint is not watertight. The concrete sits on the footer that was poured to support the wall. If water is underneath the floor concrete slab and is under pressure it will seep through this joint and enter the basement. The problem is called to high a level of hydrostatic pressure.

The remedy for water seepage caused by hydrostatic pressure is to lay perforated drainage piping below the concrete floor around the perimeter of the floor. It is best if this is done on the interior of the basement, as shown in Figure 16, where the collected water is delivered to a sump pump to be removed. However, it can be treated on the exterior of the home by excavating to the footers and adding perforated drainage piping around the foundation as shown in Figure 16b.

Placement of drainage pipe on interior and exterior walls
Figure 16b - Placement of drainage pipe on interior and exterior walls

A common mistake made by homeowners is to seal the cove joint. If the water pressure is at a level where it will enter the basement area through the cove joint, and you do not provide any relief for the pressure, sealing the cove joint can cause the basement floor to heave and crack.

Continued...